Fixed Cycle Parameters; G73N (For M System Only); G83 N; Cdz-Vale (For L System Only) - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters

15.2 Fixed Cycle Parameters

#8012

G73n (for M system only)

Set the return amount for G73 (step cycle).
---Setting range---
0 to 99999.999 (mm)
#8013

G83 n

Set the return amount for G83 (deep hole drilling cycle).
---Setting range---
0 to 99999.999 (mm)
#8014

CDZ-VALE (for L system only)

Set the chamfering amount for G76, G78 (thread cutting cycle).
---Setting range---
0 to 127 (0.1 lead)
#8015 CDZ-ANGLE (for L system only)
Set the chamfering angle for G76, G78 (thread cutting cycle).
---Setting range---
0 to 89 (°)
#8016 G71 MINIMUM (for L system only)
Set the minimum value of the last cutting amount by the rough cutting cycle (G71, G72).
The cutting amount of the last cutting will be the remainder. When the remainder is smaller than this param-
eter setting, the last cycle will not be executed.
---Setting range---
0 to 999.999 (mm)
#8017 G71 DELTA-D (for L system only)
Set the change amount of the rough cutting cycle.
The rough cutting cycle (G71, G72) cutting amount repeats x+dx, x, x-dx using the value (x) commanded with
D as a reference. Set the change amount dx.
---Setting range---
0 to 999.999 (mm)
#8018 G84/G74 n
Set the retract amount m in a G84/G74/G88 pecking tapping cycle.
(Note) In the case of a normal tapping cycle, set to "0".
---Setting range---
0 to 999.999 (mm)
#8051 G71 THICK
Set the amount of cut-in by the rough cutting cycle (G71, G72)
---Setting range---
0 to 99999.999 (mm)
#8052 G71 PULL UP
Set the amount of pull-up when returning to the cutting start point for the rough cutting cycle (G71. G72).
---Setting range---
0 to 99999.999 (mm)
#8053 G73 U
Set the X-axis cutting margin of the forming rough cutting cycle (G73).
---Setting range---
-99999.999 to 99999.999 (mm)
IB-1501279-H 218