Mitsubishi Electric M800 Series Manual page 399

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1087 G96_G0
Select how to handle the surface speed for the G00 command when using the constant surface speed control
function.
0: Calculate the surface speed constantly even during G00 movement
1: Calculate the surface speed at the block end point in the G00 command
#1088 G30SL
Select how to handle the soft limit during G30 (2nd reference position return).
0: Enable
1: Disable
#1091 Mpoint
Select how to handle the middle point during G28 and G30 reference position return.
0: Pass the middle point designated in the program and move to the reference position.
1: Ignore the middle point designated in the program and move straight to the reference position.
#1092 Tchg _A
Select the movement of the additional axis at the tool change position return command.
0: The additional axis will not move
1: After the standard axis returns, the additional axis will also return to the tool change position
#1093 Wmvfin
Select the timing of synchronization between part systems when using the multi-part system.
When the travel command is found in the synchronization command (!, M) block:
0: Synchronize before executing travel command
1: Synchronize after executing travel command
#1094 Tl_SBK
Select whether to count the data units to be used for single block operation when using the tool life manage-
ment II function (L system).
0: Not count
1: Count
#1095 T0tfof
Select how to handle TF for T00 command.
0: TF will be output
1: TF wont be output
(PR) #1096 T_Ltyp
Select the tool life management type.
1: Life management l
In this type, how long and how many times the program commanded tool is used are accumulated to
monitor the usage state.
2: Life management ll
This method is the same as tool life management I, but with the spare tool selection function.
A spare tool is selected from a group of tool commands commanded in the program.
Tool compensation (tool length compensation and tool radius compensation) is carried out for the select-
ed tool.
3: Life management lll (for M system only)
The usage time or frequency of use which is designated by the program is accumulated, and the tool
usage state is monitored.
It is not managed by the group number.
(Note) When "3" is set for the L system, the Life management l is selected.
#1097 Tldigt
Select the number of digits for an offset No. in command T.
0: Lower two digits of command T serve as an offset No.; the remaining upper digits as a tool No.
1: Lower one digit of command T serves as an offset No.; the remaining upper digits as a tool No.
2: Lower two digits of command T serve as an offset No., the remaining upper digits as a tool No.
3: Lower three digits of command T serve as an offset No.; the remaining upper digits as a tool No.
IB-1501279-H
Constant surface speed control by rapid traverse feed
command
Disable G30 soft limit
Ignore middle point
Replace tools for additional axis
Synchronization between part systems method
Select life count for single block (for L system only)
TF output (for L system only)
Tool life management type
Tool offset No. digits selection
382