Block Stop Cmnd In User Macro; Mdi Completed; Block Start Interlock; Cutting Blck Start Interlock - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:

Table of Contents

M800/M80/E80/C80 Series Alarm/Parameter Manual

2 Stop Codes (T)

Block stop cmnd in user macro

A block stop command was issued in the user macro program.

Press the CYCLE START switch to resume the automatic operation.

Operation mode changed

Automatic mode changed to another automatic mode.

Return to the original automatic operation mode, and press the CYCLE START switch to resume the au-

tomatic operation.

MDI operation has ended the last block.

Set the MDI operation again, and press the CYCLE START switch to start the MDl operation.

The interlock signal, which locks the block start, is ON.

Correct the sequence program.

The interlock signal, which locks the block cutting start, is ON.

Correct the sequence program.

Safe speed clamp is ON

One of the following commands was issued during the safe speed clamp:

thread cutting, synchronous tapping, cross machining, superimposition control, tool center point control or SSS

Turn ON the safely-limited speed monitoring request signal before performing the operation.

Perform the operation with the door closed.

Inclined Z offset change

The "inclined axis control: No Z axis compensation" signal has turned ON or OFF during the program operation.

Press the CYCLE START switch to resume the automatic operation.

Aux axis changeover error

The "NC axis control selection" signal was turned OFF while a NC axis was traveling.

Turn the "NC axis control selection" signal ON and press the CYCLE START switch to resume the auto-

matic operation.

IB-1501279-H

Show Quick Links

Table of Contents

C80 series M80 series E80 series