High-Accuracy Control Parameters; Cireft; G0Bdcc; G1Bf - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters

15.11 High-accuracy Control Parameters

#1149

cireft

Select whether to decelerate at the arc entrance or exit.
0: Not decelerate
1: Decelerate
#1205

G0bdcc

0: Post-interpolation acceleration/deceleration is applied to G00.
1: Pre-interpolation acceleration/deceleration is applied to G00 even in the high accuracy control mode.
2: Rapid traverse constant inclination multi-step acceleration/deceleration is enabled.
When the multi-part system simultaneous high-accuracy control option is enabled, "1" can be set for the
2nd part system and the following.
#1206

G1bF

Set a cutting feedrate when applying pre-interpolation acceleration/deceleration.
When high-accuracy control time constant expansion is valid, set the maximum of cutting feed clamp speed
of each axis.
---Setting range---
1 to 999999 (mm/min)
#1207 G1btL
Set a cutting feed time constant when applying pre-interpolation acceleration/deceleration.
When set to "0", the time constant will be clamped at 1ms.
Speed
G1bF
---Setting range---
Without high-accuracy control time constant expansion: 1 to 5000 (ms)
With high-accuracy control time constant expansion: 1 to 30000 (ms)
Cutting feed Acc
Displays cutting feed acceleration.
#1209 cirdcc
Set the deceleration speed at the arc entrance or exit.
---Setting range---
1 to 999999 (mm/min)
#1568 SfiltG1
Set the filter time constant for smoothly changing the acceleration rate for the cutting feed acceleration/de-
celeration in pre-interpolation acceleration/deceleration.
- Notch frequency Hz
Displays the notch frequency (Hz) for the S-pattern filter set in "#1568 SfiltG1" (G01 soft acceleration/decel-
eration filter).
---Setting range---
0 to 200 (ms)
IB-1501279-H
G1btL
Cutting feed acceleration
Arc deceleration speed change
Acceleration and deceleration before G0 interpolation
Maximum speed
Time constant
Time
Arc deceleration speed
G01 soft acceleration/deceleration filter
280