M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P220
No spec: Special fixed cycle
Details
There are no special fixed cycle specifications.
Remedy
Check the specifications.
P221
No. of special fixed holes = 0
Details
"0" has been specified for the number of holes in special fixed cycle mode.
Remedy
Correct the program.
P222
G36 angle error
Details
A G36 command specifies "0" for angle intervals.
Remedy
Correct the program.
P223
G12/G13 radius error
Details
The radius value specified with a G12 or G13 command is below the compensation amount.
Remedy
Correct the program.
P224
No spec: Circular (G12/G13)
Details
There are no circular cutting specifications.
Remedy
Check the specifications.
P230
Subprogram nesting over
Details
Over 10 times of subprogram calls have been done in succession from a subprogram.
A M198 command was found in the program in the data server.
Remedy
Correct the program so that the number of subprogram calls does not exceed 10 times.
P231
No sequence No.
Details
The sequence No., commanded at the return from the subprogram or by GOTO in the subprogram call, was
not set.
Remedy
Specify the sequence Nos. in the call block of the subprogram.
P232
No program No.
Details
The machining program has not been found when the machining program is called.
Remedy
Enter the machining program.
Check the subprogram storage destination parameters.
Ensure that the external device (including SD card/USB memory) that contains the file is mounted.
137
IB-1501279-H