Nrefn; Zerbas - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#2058

nrefn

Set the negative direction width where the near reference position signal is output.
When set to "0", the value is the same as #2218 SV018(PIT).
(Note) When "#1240 set12/bit2" is ON, a magnification (C: 10-fold, D: 100-fold, E:1000-fold) corresponding
to the input setting increment ("#1003 iunit") will be applied to the setting value.
---Setting range---
0 to 999.999 (mm)
(Input setting increment applied)
#2059

zerbas

Select which is to be the zero point coordinate position during absolute position initial setting.
0: Position where the axis was stopped.
1: Grid point just before stopper.
IB-1501279-H
Near zero point -
Select zero point parameter and basic point
512