Astap_Timeadj; Cpuunitnum; Devcondenseref - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#11718

astap_timeadj

[M8]
This parameter enables you to adjust the motion start timing of the tap axis and the spindle in analog spindle
synchronous tapping.
(1) When the setting = 0
Not adjust the timing.
(2) When the setting > 0
Delay the start of tap axis command by the specified length of time.
This is effective when the analog spindle lags behind the tap axis.
(3) When the setting < 0
Delay the start of analog spindle command by the specified length of time.
This is effective when the analog spindle runs ahead of the tap axis.
---Setting range---
-50 to 50 (ms)
(PR) #26750

CPUUnitNum

[C80]
Specify the number of CPU modules that configure a multiple CPU system.
When set to "0", the number of CPU modules is considered as 2.
(Note) Set the identical value for all the CPU modules.
---Setting range---
0 to 4 (units)
(PR) #26751

DevCondenseRef

[C80]
Select whether to use the compression setting for the R devices refreshed at END in such a case as when
a system is configured with 3 CNC modules.
0: Not use
1: Use
Analog spindle synch tap: Timing adjustment
Number of CPU modules
Compressed device refresh ON
467 IB-1501279-H