G0Tl; G0T1 - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#2004

G0tL

Set a linear control time constant for rapid traverse acceleration and deceleration.
The time constant will be enabled when LR (rapid traverse feed with linear acceleration/deceleration) or F
(soft acceleration/deceleration) is selected in "#2003 smgst Acceleration and deceleration modes".
Speed
G0tL
---Setting range---
1 to 4000 (ms)
#2005

G0t1

Set a primary-delay time constant for rapid traverse acceleration and deceleration.
The time constant will be enabled when R1 (rapid traverse feed with primary delay) or R3 (exponential ac-
celeration and linear deceleration) is selected in "#2003 smgst Acceleration and deceleration modes".
When the soft acceleration/deceleration is selected, the second-step time constant will be used.
<Rapid traverse feed with primary delay>
Speed
G0t1
<Rapid traverse feed with exponential acceleration and linear deceleration>
Speed
G0t1
<Soft acceleration/deceleration>
When "#1219 aux03/bit7" is set to "0"
Speed
G0t1
G0tL
(Note) The time constant setting for the soft acceleration/deceleration can be changed by the setting of
"#1219 aux03/bit7"
---Setting range---
1 to 5000 (ms)
IB-1501279-H
G0tL
G0t1
2 x G0t1
G0t1
G0t1
G0t1
G0tL
470
G0 time constant (linear)
Time
G0 time constant(primary delay) / Second-step time
constant for soft acceleration/deceleration
Time
Time
Time