Multi_Sp_Syn; Tcode_Method_Chg; Tol-Custom-Nondisp; Tlno.hold - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1440

multi_sp_syn

Select whether to enable multiple spindle synchronization.
0: Disable
1: Enable
(PR) #1441

Tcode_Method_Chg

Select the tool command method.
0: Tool life management II format
1: Tool function
#1442 G0ol
Select whether to enable the G00 rapid traverse overlap function.
0: Disable
1: Enable
#1443 G28ol
Select whether to enable the G28 rapid traverse overlap function.
0: Disable
1: Enable
#1444 otsys
Select whether to stop all the part systems or only the part system whereH/W-OT, soft limit or interference
check alarm has occurred.
(Note) If H/W-OT, soft limit or interference check alarm has occurred on an axis related to superimposition,
synchronization, arbitrary axis superimposition, or synchronization during axis traveling, the part system to
which the superimposition (synchronous) and basic axes belong is treated as the one where the alarm has
occurred.
0: Stop each part system
1: Stop all the part systems
(PR) #1445

Tol-Custom-nondisp

Select whether to display or hide additional information on the tool management screen.
0: Display
1: Not display
#1446

Tlno.hold

Select the operation to be performed when command T has no tool length offset No.
0: Tool length offset No. is deemed as 0.
1: Last commanded tool length offset No. is applied.
(Tool length offset No. is unchanged.)
#1447 G96_tmp_cancel
0: Disable a spindle rotation command given in another part system
1: Enable a spindle rotation command given in another part system
#1448 Sclamp_err_cancel
0: Disable cancel of the error
1: Enable cancel of the error
#1449 m_clamp_on
0: Rapid traverse rate (#2001 rapid) serves as the maximum speed in jog, handle, incremental or manual
reference position return (high-speed) mode. However you can use a PLC device to switch the maxi-
mum speed to the manual feed clamp speed (#2614 m_clamp).
1: Manual feed clamp speed (#2614 m_clamp) serves as the maximum speed in jog, handle, incremental,
or manual reference position return (high-speed) mode.
Multiple spindle synchronization valid
T command method selection
Enable G00 rapid traverse overlap
Enable G28 rapid traverse overlap
Stop all part systems at OT
Non-display of additional info on tool management
screen
Tool length offset No. retention
Temporary cancel of constant surface speed control
Cancel of the error for absence of spindle speed clamp
Manual feed rate clamp ON
447 IB-1501279-H