Mitsubishi Electric M800 Series Manual page 448

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1293 ext29
bit0: Synchronous feed in milling
Select whether to enable synchronous feed in milling interpolation, cylindrical interpolation or polar coordi-
nate interpolation mode.
0: Disable
1: Enable
bit1: Enabling N0 command
Select how to handle a command of sequence number zero (N0).
0: N0 causes an error.
1: N0 is ignored (causes no error).
(PR) #1294 ext30
Not used. Set to "0".
(PR) #1295 ext31
bit6: Analog spindle synchronous tapping ON
[M8]
Select whether to enable analog spindle synchronous tapping.
0: Disable
1: Enable
(PR) #1296 ext32
Not used. Set to "0".
(PR) #1297 ext33
Not used. Set to "0".
(PR) #1298 ext34
Not used. Set to "0".
(PR) #1299 ext35
Not used. Set to "0".
431 IB-1501279-H