No Spec: Cnst Surface Ctrl G96; Spindle Rotation Speed S=0; Illegal P-No. G96; G96 Clamp Err. - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P131

No spec: Cnst surface ctrl G96

Details
A constant surface speed control command (G96) was issued though it is out of specifications.
Remedy
Check the specifications.
Issue a rotation speed command (G97) instead of the constant surface speed control command (G96).
P132

Spindle rotation speed S=0

Details
No spindle rotation speed command has been issued.
Remedy
Correct the program.
P133

Illegal P-No. G96

Details
The illegal No. was specified for the constant surface speed control axis.
Remedy
Correct the parameter settings and program that specify the constant surface speed control axis.
P134

G96 Clamp Err.

Details
The constant surface speed control command (G96) was issued without commanding the spindle speed clamp
(G92/G50).
Remedy
Press the reset key and carry out the remedy below.
Check the program.
Issue the G92/G50 command before the G96 command.
Command the constant surface speed cancel (G97) to switch to the rotation speed command.
P140 No spec: Pos compen cmd
Details
The position compensation command (G45 to G48) is out of specifications.
Remedy
Check the specifications.
P141 Pos compen during rotation
Details
Position compensation was commanded during the figure rotation or coordinate rotation command.
Remedy
Correct the program.
P142 Pos compen invalid arc
Details
Position compensation cannot be executed with the issued arc command.
Remedy
Correct the program.
P150 No spec: Nose R compensation
Details
Tool radius compensation commands (G41 and G42) were issued though they are out of specifications.
Nose R compensation commands (G41, G42, and G46) were issued though they are out of specifications.
Remedy
Check the specifications.
131 IB-1501279-H