Plc Device Too Much; Illegal Command Value; Dia/Rad Selection Cmd Invalid; Invld Cmd In Dia/Rad Selection - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P657

PLC Device too much

Details
Multiple assignment expressions which include the PLC direct interface command are commanded to the same
block.
Remedy
Command the assignment command using PLC direct interface by itself.
P700

Illegal command value

Details
Spindle synchronization was commanded to a spindle that is not connected serially.
Remedy
Correct the program.
Correct the parameter settings.
P705

Dia/Rad selection cmd invalid

Details
G10.9 was commanded during a modal in which diameter/radius designation selection is not available.
Remedy
Check the program.
P706

Invld cmd in dia/rad selection

Details
A G code impossible to command was issued during switching between diameter and radius using the diame-
ter/radius designation selection.
Remedy
Check the program.
P801 Turning tool offset disabled
Details
Any of the following commands has been given during the G43.7 mode.
Mirror image by G code
Mirror image by parameter setting
Mirror image by external input
Tool length compensation along the tool axis
Automatic tool length measurement
A G43.7 command has been given in any of the following modes.
Mirror image by G code
Mirror image by parameter setting
Mirror image by external input
Fixed cycle for drilling
Remedy
Check the program. If you use the mirror image, tool length compensation along the tool axis, automatic
tool length measurement or fixed cycle for drilling, use a G49 command to cancel the tool position offset.
P802 Nose R compensation disabled
Details
Any of the following commands has been given during nose R compensation for machining center system.
Mirror image by G code
Mirror image by parameter setting
Mirror image by external input
Nose R compensation for machining center system has been executed in any of the following modes.
Mirror image by G code
Mirror image by parameter setting
Mirror image by external input
Remedy
Check the program. If you use the mirror image, use a G40 command to cancel the nose R compensation
for machining center system.
155 IB-1501279-H