Intrf Check Across Sys: Alarm; Interfe Chk 0Pt Return Incomp; Feed-Forward Control Disabled; Superimposition Axis Param Err - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

Intrf check across sys: Alarm

Details
A command has been given that causes the interfering objects to collide each other.
Remedy
Correct the program.
M01

Interfe chk 0pt return incomp

Details
Interference check between part systems had started while zero point return of the part system set interfering
object has not completed.
Remedy
Turn OFF the interference check valid signal, and complete zero point return in the all part systems set
interfering object.
M01

Feed-forward control disabled

Details
Feed-forward control was attempted while any of the following functions was enabled.
Control axis superimposition I/II
Control axis synchronization between part systems I/II
Remedy
Turn OFF the feed-forward control request signal.
M01

Superimposition axis param err

Details
Cutting feed clamp rate is unspecified for a superimposition-related axis. Or the specified rate is outside
the setting range.
"#2091 plclamp", "#2629 pl3clamp" or "#2630 pl3clamp2"
Rapid traverse rate is unspecified for a superimposition-related axis.
Or the specified rate is outside the setting range.
"#2090 plrapid", "#2621 plrapid2",
"#2626 pl3rapid", "#2627 pl3rapid2" or "#2628 pl3rapid3"
Remedy
Set the cutting feed clamp rate of the superimposition-related axis within the setting range.
Set the rapid traverse rate of the superimposition-related axis within the setting range.
M01 Tool retract & return disabled
Details
Tool retract and return command has been given in any of the following modes:
 Mixed control (Cross axis control) I
 Mixed control (Cross axis control) II
 Control axis synchronization between part systems I
 Control axis synchronization between part systems II
 Control axis superimposition I
 Control axis superimposition II
 Arbitrary axis superimposition control
 Tool spindle synchronization IA (spindle - spindle polygon)
 Tool spindle synchronization IB (spindle - spindle polygon)
 Tool spindle synchronization IC (spindle - NC axis polygon)
 Tool spindle synchronization II (hob)
 Spindle superimposition control
Remedy
Turn OFF the transit point designation signal.
M01 Arbitrary axis unexchangeable
Details
The axis declared in the arbitrary axis exchange command is incapable of being exchanged.
Remedy
Correct the program (mainly check the processing timing).
29
1052
1053
1060
1070
1080
1101
IB-1501279-H