Mitsubishi Electric M800 Series Manual page 450

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1304 V0comN
Set the number of common variables, common for part systems, starting from address #500.
This is valid only when "#1052 MemVal" is set to "1".
---Setting range---
0 to 500
#1306 InpsTyp
Select the parameter specification type for the G0 or G1 deceleration check.
0: Deceleration check specification type 1
G0 is specified with "#1193 inpos", and G1+G9 with "#1223 aux07/bit1".
1: Deceleration check specification type 2
G0 or G1+G9 is specified with "#1193 inpos".
(PR) #1307 G0acc_plc
[C80]
Set a type of acceleration/deceleration for the rapid traverse command.
0: Time constant acceleration/deceleration (conventional method)
1: Constant inclination acceleration/deceleration
(PR) #1308 G1acc_plc
[C80]
Select the type of acceleration/deceleration for the cutting feed command.
0: Time constant acceleration/deceleration (conventional method)
1: Constant inclination acceleration/deceleration
(PR) #1309 GType
Select which is used to command the reverse tap.
0: G84.1/G88.1
1: D command with the value changed to negative
#1310 WtMmin
Set the minimum value for the M code. When "0" is set, the synchronization M code will be invalid.
---Setting range---
0, 100 to 99999999
#1311 WtMmax
Set the maximum value for the M code. When "0" is set, the synchronization M code will be invalid.
---Setting range---
0, 100 to 99999999
#1312 T_base
Set the standard No. for the tool life management.
When the value specified by the T code command exceeds the set value in this parameter, the set value will
be subtracted from the command value, which will be used as tool group No. for tool life management.
When the value specified by the T code command is equal to or less than the set value, the T code will be
handled as a normal T code and not subjected to tool life management.
When "0" is set in this parameter, the T code command will always specify a group No. (Valid for M-system
tool life management II.)
---Setting range---
0 to 9999
No. of #500 address part system common variables
Deceleration check specification type
PLC axis G00 constant inclination valid
PLC axis G01 constant inclination valid
Switch command format
Minimum value for synchronization M code
Maximum value for synchronization M code
Tool life management standard number
433 IB-1501279-H