Gcode Rotat (For L System Only); G68.1 R Inc (For L System Only); Coord Rot Plane (H); Coord Rot Plane (V) - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8081

Gcode Rotat (for L system only)

Set the rotation angle for the program coordinate rotation command.
This parameter is enabled when "1" is set in "#1270 ext06/bit5 (Coordinate rotation angle without com-
mand)".
This parameter is set as absolute value command regardless of the "#8082 G68.1 R INC" setting. If the ro-
tation angle is designated by an address R in G68.1 command, the designation by program will be applied.
---Setting range---
-360.000 to +360.000 (°)
#8082

G68.1 R INC (for L system only)

Select absolute or increment command to use for the rotation angle command R at L-system coordinate ro-
tation.
0: Use absolute value command in G90 modal, incremental value command in G91 modal
1: Always use incremental value command
(Note) If G91 does not exist in the G code system, the command type is decided by this parameter only.
#8621

Coord rot plane (H)

Set the plane (horizontal axis) for coordinate rotation control.
Usually, set the name of the 1st axis.
When this parameter is not set, the coordinate rotation function will not work.
---Setting range---
Axis name
#8622

Coord rot plane (V)

Set the plane (vertical axis) for coordinate rotation control.
Usually, set the name of the 2nd axis.
When this parameter is not set, the coordinate rotation function will not work.
---Setting range---
Axis name
#8623 Coord rot centr (H)
Set the center coordinates (horizontal axis) for coordinate rotation control.
---Setting range---
-999999.999 to 999999.999 (mm)
#8624 Coord rot centr (V)
Set the center coordinates (vertical axis) for coordinate rotation control.
---Setting range---
-999999.999 to 999999.999 (mm)
#8625 Coord rot vctr (H)
Set the vector components (horizontal axis) for coordinate rotation control.
When this parameter is set, the coordinate rotation control angle (#8627) will be automatically calculated.
---Setting range---
-999999.999 to 999999.999 (mm)
#8626 Coord rot vctr (V)
Set the vector components (vertical axis) for coordinate rotation control.
When this parameter is set, the coordinate rotation control angle (#8627) will be automatically calculated.
---Setting range---
-999999.999 to 999999.999 (mm)
IB-1501279-H 208