Milling Init G19; G83/87 Rapid; Font Selection; Screen Capture - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8114

Milling Init G19

Set which plane to execute for milling machining after the power is turned ON or reset.
#8113:0, #8114:0 ---> G17 plane
#8113:0, #8114:1 ---> G19 plane
#8113:1, #8114:0 ---> G16 plane
#8113:1, #8114:1 ---> G16 plane
0: Not G19 plane
1: G19 plane
(Note) This parameter is valid for the G code system 2, 3, 4 or 5 ("#1037 cmdtyp"="3", "4", "5" or "6").
#8115

G83/87 RAPID

Select the operation upon the completion of each step in deep hole drilling cycle (G83, G87).
0: Returns to R point before performing next step.
1: Returns by the amount of d (parameter setting) setting value before performing next step.
#8116 CoordRotPara invd
Select whether to enable the coordinate rotation by the parameters.
0: Enable
1: Disable
#8117 OFS Diam DESIGN
Select tool radius or tool diameter compensation amount to be specified.
0: Tool radius compensation amount
1: Tool diameter compensation amount
#8119 Comp. unit switch
Select the setting unit of compensation amount that has no decimal point.
0: 1mm (or 1inch) unit
1: The minimum command unit (follows "#1003 iunit")
#8120

FONT SELECTION

[M8]
Select the font when Simplified Chinese is selected for "#1043 lang".
0: MITSUBISHI CNC GOTHIC font
1: Standard Windows font
*This parameter is available for M800W only.
[C80]
Not used.
#8121

Screen Capture

[M8]
Select whether to enable the screen capture function.
0: Disable
1: Enable
(Note 1) By setting this parameter to "1", and by keeping pushing the [SHIFT] key, screen capture will be
executed.
[C80]
Not used.
223 IB-1501279-H