Rt2G0Tl; Rt2G1Tla; Rt2G1Tlb; Rt2 G0Rng - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#2653

RT2G0tL

Set the minimum value of time constant when changing time constant during acceleration and deceleration
of G0 command.
Set the time constant which was adjusted when workpiece is not attached.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
#2654

RT2G1tLA

Set the minimum value when changing time constant during acceleration and deceleration of G1 command
after interpolation.
Set the time constant which was adjusted when workpiece is not attached.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
#2655

RT2G1tLB

Set the minimum value when changing time constant during acceleration and deceleration of G1 command
before interpolation.
Set the time constant which is adjusted when workpiece is not attached.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
#2656

RT2 G0rng

Set the changing amount of time constant when changing time constant during acceleration and deceleration
of G0 command based on the estimated inertia ratio.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
#2657 RT2G1rngA
Set the changing amount of time constant when changing time constant during acceleration and deceleration
of G1 command after interpolation based on the estimated inertia ratio.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
#2658 RT2G1rngB
Set the changing amount of time constant when changing time constant during acceleration and deceleration
of G1 command before interpolation based on the estimated inertia ratio.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
#2659 tolerance
Specify a tolerance (tolerable error) to be used under tolerance control.
Set a tolerable error for fine segment program created by CAM.
(Usually around 0.01(mm))
If 0.000 is set, it is operated with the tolerance of 0.01(mm).
When designating the tolerance amount with the ", K address", this parameter is not used.
---Setting range---
0.000 to 100.000 (mm)
RT2: Minimum value of G0 acce/dece time constant
RT2: Minimum value of acce/dece time constant after G1
interpolation
RT2: Minimum value of acce/dece time constant before
G1 interpolation
RT2: Changing amount of G0 acce/dece time constant
RT2: Changing amount of acce/dece time constant after
G1 interpolation
RT2: Changing amount of acce/dece time constant before
G1 interpolation
Tolerance
501 IB-1501279-H