Mitsubishi Electric M800 Series Manual page 366

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1172 tapovr
Set the override value when leaving the tap end point in the synchronous tapping cycle.
When "0" is set, 100 % is applied for the operation.
---Setting range---
0 to 999 (%)
#1173 dwlskp
Set the skip signal for ending the G04 (dwell) command.
PLC interface input signal
Skip3 Skip2 Skip1
0 : -
1 : -
2 : -
3 : -
4 : *
5 : *
6 : *
7 : *
(* : Enable - : Disable)
#1174 skip_F
Set the feedrate when there is no F command in the program at G31 (skip) command.
---Setting range---
1 to 999999 (mm/min)
#1175 skip1
Designate the skip signal in multi-step skip G31.1.
The setting method is same as "#1173 dwlskp".
#1176 skip1f
Set the skip feedrate in multi-step skip G31.1.
---Setting range---
1 to 999999 (mm/min)
#1177 skip2
Set the skip signal in multi-step skip G31.2.
The setting method is same as "#1173 dwlskp".
#1178 skip2f
Set the skip signal in multi-step skip G31.2.
---Setting range---
1 to 999999 (mm/min)
#1179 skip3
Set the skip signal in multi-step skip G31.3
The setting method is same as "#1173 dwlskp".
#1180 skip3f
Set the skip signal in multi-step skip G31.3.
---Setting range---
1 to 999999 (mm/min)
- -
- *
* -
* *
- -
- *
* -
* *
349
Tap return override
G04 skip condition
G31 skip speed
G31.1 skip condition
G31.2 skip speed
G31.2 skip condition
G31.2 skip speed
G31.3 skip condition
G31.3 skip speed
IB-1501279-H