Aut/Manual Switch; Edit Undo; Navi-Message On - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8905 Counter type 5
Select the type of counter on the Monitor screen (Simple display).
Either relative position or tip work position is displayed by default.
(Note 1) Tip work position is displayed when 5-axis-related option or program format switch option is ON.
(Note 2) PLC axis position is displayed when "#11091 PLC counter valid" is "1". [M8]
1: Current position
2: Workpiece coordinate position
3: Machine position
4: Program position
8: Remain command
9: Manual interrupt amount
10: Next command
11: Restart position
12: Remain distance
16: Tip workpiece coordinate position
18: Tool axis movement
19: Tip machine position
20: Relative position
21: Table coordinate position
22: Workpiece installation position
23: Inclined surface coordinate position
[M8]
27: PLC axis position
---Setting range---
1 to 27
#8906 Counter type 6
Not used. Set to "0".
(PR) #8909

Aut/Manual switch

Select the counter display method on Monitor screen.
0: "AUTO/MDI" and "Manual" display is switched by the mode selection switch.
1: Display AUTO/MDI counter only.
2: Display Manual counter only.
3: Display the enlarged counter of "#8901 Counter type 1".
(Note) This parameter is disabled when "#11019 2-system display (2-part system simultaneous display)" is
set to "1" or "2".
#8910

Edit undo

Set whether to enable the Undo function during program edit on the Monitor screen or Edit screen.
0: Disable
1: Enable
(Note) This parameter is valid for M800W/M800S Series.
#8911

NAVI-Message ON

[M8]
Select whether or not to display a confirmation message upon rewrite of common variable in NAVI operation.
0: Not display a confirmation message
1: Display a confirmation message
295 IB-1501279-H