5Axis_Spec - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1450

5axis_Spec

bit0: Axis name setting method of rotary axis configuration parameter
Select the axis name setting method for rotary axis configuration parameter (#7900, #7901, #7902, #7922,
#7932, #7942, #7952).
0: Set by axis name
1: Set by 2nd axis name
bit1: Using G174 tool axis rotation angle as compensation amount
0: Specify the compensation amount using the address R and R register.
1: Use the tool axis rotation angle of G174 as the compensation amount.
bit2: Application of rotary axis configuration parameters
Select the method of applying the rotary axis configuration parameters.
0: Automatic selection method
1: PLC signal method
(Note) This parameter is enabled when "#1450 5axis_Spec/bit0 (Axis name setting method of rotary axis
configuration parameter)" is "1".
bit3: Select specifications of rotation direction parameter
[M8]
Select the specifications of rotation direction parameter (#7923, #7933, #7943, #7953).
0: The parameter specifications vary for each function.
1: The parameter specifications are common to the functions.
"#7923 DIR_T1", "#7933 DIR_T2", "#7943 DIR_W1", "#7953 DIR_W2"
0: When the tool motion viewed from the workpiece is in right-hand screw direction, it is taken as the
positive direction.
1: When the tool motion viewed from the workpiece is in left-hand screw direction, it is taken as the
positive direction.
#1451 M[M031-000](SMLK)
Register an M code to be output during high-speed simple program check.
Each bit of the set value corresponds to the M code number.
(Example) To register M05, set 00000020 in #1451.
Note that operation of the registered M code varies according to #1405 M_mode(SMLK).
---Setting range---
0 to FFFFFFFF
Set this in hexadecimal format.
#1452 M[M063-032](SMLK)
Register an M code to be output during high-speed simple program check.
Each bit of the set value corresponds to the M code number.
(Example) To register M05, set 00000020 in #1451.
Note that operation of the registered M code varies according to #1405 M_mode(SMLK).
---Setting range---
0 to FFFFFFFF
Set this in hexadecimal format.
IB-1501279-H
Special operation registration M code (High-speed sim-
ple program check)
Special operation registration M code (High-speed sim-
ple program check)
448