Minute Lengs; Fairing On; Accclamp On (For M System Only); Cordecjudge (For M System Only) - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8030 MINUTE LENGS (for M system only)
Set the fine-segment length where the spline interpolation is temporarily canceled.
When the length of one block exceeds this parameter setting value, spline interpolation is canceled tempo-
rarily and linear interpolation is performed. Set a value a little smaller than one block length of the program.
If "-1" is set, spline interpolation will be performed regardless of block length.
---Setting range---
-1 to 127 (mm)
0: 1 (mm)
#8033 Fairing ON (for M system only)
Select whether or not to use the fairing or smooth fairing function.
0: Use neither of them
1: Use the fairing function
2: Use the smooth fairing function
#8034

AccClamp ON (for M system only)

Select the method for clamping the cutting speed.
0: Clamp with parameter "#2002 clamp" or the corner deceleration function.
1: Clamp the cutting speed with acceleration judgment.
(Enabled when "#8033 Fairing ON" is set to "1".)
#8036

CordecJudge (for M system only)

Select the condition to decide a corner.
0: A corner is decided from the angle of the neighboring block.
1: A corner is decided from the angle of the neighboring block, excluding minute blocks.
(Enabled when "#8033 Fairing ON" is set to "1".)
#8037 CorJudgeL (for M system only)
Set the length of the block to be excluded when deciding a corner.
(Enabled when "#8036 CordecJudge" is set to "1".)
---Setting range---
0 to 99999.999 (mm)
#8038 Path recog. range
Path recognition range
Specify the range to recognize the tool paths adjoining to the command position when the smooth fairing
function is ON.
If "0" is set, the range will be 1.000 (mm).
---Setting range---
0 to 100.000 (mm)
#8039 Comp. range limit
Compensation distance tolerance
Specify the upper limit of the distance between the command position and compensation position when the
smooth fairing function is ON.
If you specify a negative value, operation is conducted with no tolerance limit.
If "0" is set, the tolerance will be 0.005 (mm).
---Setting range---
-1.000 to 100.000 (mm)
(PR) #8040 High-SpeedAcc
High-speed high-accuracy control-enabled part system
Select whether to enable the simultaneous use of the high-accuracy control and high-speed machining mode
(including the high-speed high-accuracy control I and II) for each part system.
0: Not enable
1: Enable
"1" can be set for up to two part systems. If you set "1" for three or more part systems, the alarm (Y51 0032)
will result.
285 IB-1501279-H