Prg Coord Rot Type; Tap Feedrate Limit; Manual Fcmd2 Clamp; Eor Disable - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#19003

PRG coord rot type

Select the start point of the initial travel command after program coordinate rotation command.
0: Calculate the end position using the current position on the local coordinate system before rotating, with-
out rotating the start point in accordance with the coordinates rotation.
1: Calculate the end position, assuming that the start point rotates in accordance with the coordinates ro-
tation.
#19004

Tap feedrate limit

Set the upper limit of the cutting feed rate in synchronous tapping.
---Setting range---
0 to 1000(mm/rev)
(Note) Setting "0" disables this parameter.
When the commanded cutting feed rate in synchronous tapping exceeds this setting, a program error
(P184) will occur.
#19005

manual Fcmd2 clamp

Set a clamp speed coefficient (%) for manual speed command 2.
The feed rate is clamped at the command feed rate or rapid traverse rate for automatic operation, which was
multiplied by this parameter's value.
(Note) This setting is valid only for manual speed command 2.
---Setting range---
0 to 1000 (%)
0: 100% (Default value)
(PR) #19006

EOR Disable

Set whether to handle an EOR(%) in machining program as the end of program in automatic operation,
graphic check, program transfer to NC memory, program editing, and buffer correction. Tape operation,
Computer Link B, and serial input/output are not included.
0: An EOR(%) is handled as the end of machining program.
1: An EOR(%) is not handled as the end of machining program. The program will be read to the end of file.
#19007 Prg check constant
Program check speed constant
Set the speed constant to be used for the program check operation function.
---Setting range---
0 to 60000
#19008 PRM coord rot type
Select the start point of the initial travel command after parameter coordinate rotation.
0: Calculate the end position, assuming that the start point rotates in accordance with the coordinates ro-
tation.
1: Calculate the end position using the current position on the local coordinate system before rotating, with-
out rotating the start point in accordance with the coordinates rotation.
#19009 Corner check angle
Corner deceleration check angle
Specify the internal angle formed by two blocks, at or below which the block joint is determined as a corner
and the latter block's start timing is controlled accordingly while the automatic error detect is ON.
N001
---Setting range---
0 to 180 (°)
N002
θ
213 IB-1501279-H