M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P110
Plane select during figure rot
Details
Plane selection (G17/G18/G19) was commanded during figure rotation.
Remedy
Correct the machining program.
P111
Plane selected while coord rot
Details
Plane selection commands (G17, G18, G19) were issued during a coordinate rotation was being commanded.
Remedy
Always command coordinate rotation cancel after the coordinate rotation command, and then issue a
plane selection command.
P112
Plane selected while R compen
Details
Plane selection commands (G17, G18, G19) were issued while tool radius compensation (G41, G42) and
nose R compensation (G41, G42, G46) commands were being issued.
Plane selection commands were issued after completing nose R compensation commands when there
were no further axis movement commands after G40, and compensation has not been cancelled.
Remedy
Issue plane selection commands after completing (axis movement commands issued after G40 cancel
command) tool radius compensation and nose R compensation commands.
P113
Illegal plane select
Details
The circular command axis does not correspond to the selected plane.
Remedy
Select a correct plane before issuing a circular command.
P114
Plane axis command error
Details
The axis specified in the fixed cycle for turning machining does not coincide with the selected plane.
One or both of the selected plane axes have no travel when the fixed cycle for turning machining is com-
manded.
Remedy
Correct the plane selection before issuing the fixed cycle for turning machining.
Correct the program so that the two axes of the selected plane are involved in the movement of the fixed
cycle for turning machining.
P120
No spec: Feed per rotation
Details
Feed per rotation (G95) was commanded though it is out of specifications.
Remedy
Check the specifications.
P121
F0 command during arc modal
Details
F0 (F 1-digit feed) was commanded during the arc modal (G02/G03).
Remedy
Correct the machining program.
P122
No spec: Auto corner override
Details
An auto corner override command (G62) was issued though it is out of specifications.
Remedy
Check the specifications.
Delete the G62 command from the program.
129
IB-1501279-H