Mitsubishi Electric M800 Series Manual page 393

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1062 T_cmp
Select whether the tool length compensation and wear compensation are enabled during T command exe-
cution.
0 : Tool length compensation enable
1 : Tool length compensation enable
2 : Tool length compensation disable
3 : Tool length compensation disable
#1063 mandog
Select the manual reference position return method for the second return (after the coordinate system is es-
tablished) and later.
The initial reference position return after the power ON is performed with dog-type return, and the coordinate
system will be established.
(This setting is not required when the absolute position detection is used.)
0: High speed return
1: Dog-type
(PR) #1064 svof
Select whether to correct the error when the servo is OFF.
0: Not correct the error
The command value will not change during servo OFF, and the movement amount during servo OFF will
be handled as droop. When the servo is turned ON the next time, the axis will move to the command
position where it used to be when the servo was turned OFF.
1: Correct the error
The command value and the current position will follow the feedback position. When the servo is turned
ON the next time, the axis will not move.
During servo READY OFF, the operation will be always the same as of "Correct the error". (The current po-
sition will follow the position of the axis.)
(PR) #1068 slavno
Set the axis number of the slave axis in synchronous control.
The axis number is an NC number excluding the spindle and PLC axis.
Two or more slave axis cannot be set for one master axis.
This parameter cannot be set for a slave axis.
When using the multi-part system, the relation of the master axis and slave axis cannot extend over part sys-
tems.
0: No slave axis
1 to 32: 1st axis to 32nd axis
#1069 no_dsp
Select whether to display the axis counter or not.
This setting is enabled on the counter display screen (relative position counter, etc.).
0: Display
1: Not display
#1070 axoff
Select whether to enable or disable axis removal control.
0: Disable
1: Enable
#1072 chop_ax
Select the chopping axis.
0: Non-chopping axis
1: Chopping axis
IB-1501279-H
Tool compensation function
Wear compensation enable
Wear compensation disable
Wear compensation enable
Wear compensation disable
Manual dog-type
Error correction
Slave axis number
Axis with no counter display
Axis removal
Chopping axis
376