Subbro Stor D4: Dev; Subpro Stor D4: Dir; Subpro Srch Odr D0 To D4 - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8888

Subbro stor D4: dev

[M8]
If ",D1" to ",D4" is designated in a subprogram call, the called program will be searched from the storage (de-
vice and directory) set by this parameter.
(Example) M98 P (program No.), D0
[Device] "#8880 Subpro stor D0: dev", [Directory] "#8881 Subpro stor D0: dir"
The device and directory above will be searched.
(Note 1) If the called subprogram is not found, a program error will occur.
(Note 2) If there is no designation of D0 to D4, search is done according to the settings #8890 to #8894.
(Note 3) G:HD are available for M800W only.
---Setting range---
M: Memory
G: HD
R: Memory card
D: Data server
N: USB Memory
#8889

Subpro stor D4: dir

[M8]
Select the storage destination (directory) for the subprogram.
When D4 is designated at a subprogram calling, the subprogram to be called will be searched from the di-
rectory selected with this parameter.
Refer to "#8888 Subpro stor D4: dev".
---Setting range---
Directory 48 characters
#8890-8894

Subpro srch odr D0 to D4

[M8]
Specify the search order of D0 to D4 (devices and directories storing subprograms) when ",D0" to ",D4" are
omitted from subprogram call.
Search is performed in the order from 1 to 5. When "0" is set, the device is excluded from search.
If the same value is set for more than one device, search is carried out in the order from the one with a smaller
parameter number.
If "0" is set for all the devices, the memory is searched.
---Setting range---
0 to 5
IB-1501279-H 276