Mitsubishi Electric M800 Series Manual page 370

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1204 TmirS2
Select the turrets, which correspond to the tool Nos. 33 to 64, as facing turrets for T code mirror image.
---Setting range---
0 to FFFFFFFF
#1205 G0bdcc
0: Post-interpolation acceleration/deceleration is applied to G00.
1: Pre-interpolation acceleration/deceleration is applied to G00 even in the high accuracy control mode.
2: Rapid traverse constant inclination multi-step acceleration/deceleration is enabled.
When the multi-part system simultaneous high-accuracy control option is enabled, "1" can be set for the
2nd part system and the following.
#1206 G1bF
Set a cutting feedrate when applying pre-interpolation acceleration/deceleration.
When high-accuracy control time constant expansion is valid, set the maximum of cutting feed clamp speed
of each axis.
---Setting range---
1 to 999999 (mm/min)
#1207 G1btL
Set a cutting feed time constant when applying pre-interpolation acceleration/deceleration.
When set to "0", the time constant will be clamped at 1ms.
Speed
G1bF
---Setting range---
Without high-accuracy control time constant expansion: 1 to 5000 (ms)
With high-accuracy control time constant expansion: 1 to 30000 (ms)
Cutting feed Acc
Displays cutting feed acceleration.
#1208 RCK
Set a coefficient for arc radius error compensation.
An arc radius error compensation amount can be increased or decreased between -60.0 and +20.0%.
---Setting range---
-60.0 to +20.0 (%)
#1209 cirdcc
Set the deceleration speed at the arc entrance or exit.
---Setting range---
1 to 999999 (mm/min)
G1btL
Cutting feed acceleration
Select turrets as facing turrets with T command (for L
system only)
Acceleration and deceleration before G0 interpolation
Maximum speed
Time constant
Time
Arc radius error compensation factor
Arc deceleration speed
353 IB-1501279-H