Mitsubishi Electric M800 Series Manual page 593

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#13535 spdiv27
Time constant magnification for changeover speed 7 (Gear: 01)
Specify the acceleration/deceleration time constant to be used for the spindle-mode servo control/spindle
synchronization multi-step acceleration/deceleration changeover speed 7 (sptc27) or a higher speed when
the 2nd step gear is selected. Set this as a magnification with respect to the spindle-mode servo control/spin-
dle synchronization acceleration/deceleration time constant (spt2).
---Setting range---
0 to 127
#13536 spt3
Spindle synchronization acceleration/deceleration time constant(Gear: 10)
Specify the acceleration/deceleration time constant to be used when the commanded spindle synchroniza-
tion rotation speed is changed with the 3rd gear selected during the spindle-mode servo control or spindle
synchronization control.
---Setting range---
0 to 9999(ms)
#13537 sptc31
Specify the spindle speed at which a changeover to the 1st step's acceleration/deceleration time constant is
made when the 3rd step gear is selected.
---Setting range---
0 to 99999(r/min)
#13538 sptc32
Specify the spindle speed at which a changeover to the 2nd step's acceleration/deceleration time constant
is made when the 3rd step gear is selected.
---Setting range---
0 to 99999(r/min)
#13539 sptc33
Specify the spindle speed at which a changeover to the 3rd step's acceleration/deceleration time constant is
made when the 3rd step gear is selected.
---Setting range---
0 to 99999(r/min)
#13540 sptc34
Specify the spindle speed at which a changeover to the 4th step's acceleration/deceleration time constant is
made when the 3rd step gear is selected.
---Setting range---
0 to 99999(r/min)
#13541 sptc35
Specify the spindle speed at which a changeover to the 5th step's acceleration/deceleration time constant is
made when the 3rd step gear is selected.
---Setting range---
0 to 99999(r/min)
#13542 sptc36
Specify the spindle speed at which a changeover to the 6th step's acceleration/deceleration time constant is
made when the 3rd step gear is selected.
---Setting range---
0 to 99999(r/min)
IB-1501279-H
Time constant magnification for changeover speed 7
(Gear: 01)
Spindle synchronization acceleration/deceleration time
constant(Gear: 10)
Spindle sync multistep acceleration/deceleration
changeover speed 1 (Gear: 10)
Spindle sync multistep acceleration/deceleration
changeover speed 2 (Gear: 10)
Spindle sync multistep acceleration/deceleration
changeover speed 3 (Gear: 10)
Spindle sync multistep acceleration/deceleration
changeover speed 4 (Gear: 10)
Spindle sync multistep acceleration/deceleration
changeover speed 5 (Gear: 10)
Spindle sync multistep acceleration/deceleration
changeover speed 6 (Gear: 10)
576