Mitsubishi Electric M800 Series Manual page 347

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#42619 P3-tolerance
Set the tolerance for machining condition selection parameter group for machining condition selection I func-
tion.
This is equivalent to the parameter "#2659 tolerance".
---Setting range---
0 to 100.000 (mm)
#42620 P3-G1bF
[M8]
Specify the maximum speed for the machining condition parameters of the machining condition selection I
function (equivalent to #1206 G1bF).
---Setting range---
1 to 1000000 (mm/min)
#42621 P3-Sfilt2_tol
[M8]
Specify the tolerance control soft acceleration/deceleration filter 2 for the machining condition parameters of
the machining condition selection I function (equivalent to #12070 Sfilt2_tol).
---Setting range---
0 to 200 (ms)
IB-1501279-H
Tolerance for machining condition selection I
Machining condition selection I: maximum speed
Machining condition selection I: tolerance control soft
accel/decel filter 2
330