Manualb Rotcent Erh; Manualb Rotcent Erv - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#12003

ManualB RotCent erH

Set the machine coordinate position (horizontal axis) at the center of the rotary axis.
---Setting range---
-99999.999 to 99999.999 (mm)
#12004

ManualB RotCent erV

Set the machine coordinate position (vertical axis) at the center of the rotary axis.
---Setting range---
-99999.999 to 99999.999 (mm)
(PR) #12005 Mfig
Set the number of M that can be specified within the same block.
---Setting range---
1 to 4
(PR) #12006 Mbin
Data type 0
Data type 1
Data type -1
<For unsigned binary>
The absolute value "1" is output for "-1".
<For singed binary>
"-1" is output as "0xFFFFFFFF".
---Setting range---
Data type
(-1,0,1)
(PR) #12007 Sfig
Set the number of spindles.
(Note 1) The setting range differs according to the model.
(Note 2) Sfig is set in the range of 1 to 8. However, the number of outputs by Sfig cannot be controlled. Thus,
only one S command is output regardless of the Sfig setting value.
---Setting range---
1 to 8
(PR) #12008 Sbin
Data type 0 BCD
Data type 1 Unsigned binary
Data type -1 Singed binary
<For unsigned binary>
The absolute value "1" is output for "-1".
<For singed binary>
"-1" is output as "0xFFFFFFFF".
(Note 1) Sbin can be set with "-1", "0" and "1", but the S command cannot be BCD output.
If BCD (0) is selected for Sbin, it will be handled as a singed binary (-1).
---Setting range---
Data type
(-1,0,1)
IB-1501279-H
BCD
Unsigned binary
Singed binary
364
Manual feed rate B constant surface control rotation
center machine position (horizontal)
Manual feed rate B constant surface control rotation
center machine position (vertical)
Number of M
M binary
Number of S
S binary