Gb Sp Sync:phase Mem Sgnl Ilgl; Gb Sp Sync:phase Set Sgnl Ilgl; Gb Sp Sync:z Phase Not Pass; Cmnd Impsbl In Spindle Rtry Ax - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

GB SP sync:Phase mem sgnl ilgl

Details
The guide bushing spindle synchronization phase memory signal was turned ON while the master spindle
or guide bushing spindle was rotating.
The guide bushing spindle synchronization phase memory signal was turned ON while the guide bushing
spindle synchronization signal was OFF.
Remedy
Check the ladder program.
M01

GB SP sync:Phase set sgnl ilgl

Details
The guide bushing spindle synchronization phase alignment signal was turned ON while the master spin-
dle or guide bushing spindle was stopped.
Remedy
Check the ladder program.
M01

GB SP sync:Z phase not pass

Details
When the guide bushing spindle synchronization phase memory signal was ON, the master spindle or
guide bushing spindle's Z-phase was not passed.
Remedy
Check the ladder program.
M01

Cmnd impsbl in spindle rtry ax

Details
Toward the synchronous tapping spindle, the switch to servo-mode is commanded to the spindle-mode rotary
axis.
The spindle-mode rotary axis in servo-mode is commanded as the synchronous tapping spindle.
Remedy
Switch to the spindle-mode rotary axis.
M01 Other cmnd disabled in orient.
Details
Spindle superimposition control command has been given to an orientation mode spindle with the said
spindle treated as either the basic or superimposed spindle.
Orientation command has been given to the basic or superimposed spindle that is under spindle superim-
position control.
Remedy
Cancel the orientation mode.
Use G113 or the "Spindle sync cancel" signal to cancel spindle superimposition.
M01 SP-C ax ctrl runs independntly
Details
C axis mode command has been issued for polygon machining spindle.
C axis mode command has been issued for synchronized tapping spindle.
Polygon command has been issued for synchronized tapping spindle.
Spindle is being used as spindle/C axis.
Remedy
Cancel the C axis command.
Cancel the polygon machining command.
Cancel the C axis with servo OFF.
25
1021
1022
1023
1024
1025
1026
IB-1501279-H