In Absolute Position Alarm; In Abs Posn Initial Setting; In Manual Measurement; Sub Part Sys I Mode Is Active - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
2 Stop Codes (T)
T01

In absolute position alarm

Details
A start signal was input during an absolute position detection alarm.
Remedy
Clear the absolute position detection alarm, and then input the start signal.
T01

In abs posn initial setting

Details
A start signal was input during zero point initialization in the absolute position detection system.
Remedy
Complete zero point initialization before inputting the start signal.
T01

In manual measurement

Details
Automatic start is disabled because manual measurement is in execution.
Remedy
Execute automatic start after the manual measurement is completed.
T01

Sub part sys I mode is active

Details
Cycle start signal was input for the part system that has applied Sub-part system I operation mode.
Remedy
Use Sub-part system I operation mode signal to switch whether to start the operation as Sub-part system
control or to execute cycle start as Main-part system.
T01 Cycle st. prohibit(safe speed)
Details
An automatic operation was started in one of the following machining modes during the safe speed clamp:
thread cutting, synchronous tapping, cross machining, superimposition control, tool center point control or SSS
control.
Remedy
Turn ON the safely-limited speed monitoring request signal and press the cycle start button.
Close the door and press the cycle start button.
T01 Cycle start prohibit (AL Z83)
Details
Cycle start is disabled while the system alarm Z83 (NC started during SP rotation) is occurring.
Remedy
Turn OFF the power and make sure that the spindle is at a standstill. And then turn the power ON again.
T01 In interference check alarm
Details
Cycle start cannot be operated because interference check alarm is in progress.
Remedy
Release the interference check alarm before operating the cycle start.
T01 Cycle st forbid (measuring err)
Details
Cycle start cannot be executed for other part systems during measurement of rotation center error or workpiece
installation error.
Remedy
Execute cycle start for one part system that is ready for measurement.
Cancel measurement when error measurement is not executed.
IB-1501279-H 40
0138
0139
0143
0146
0165
0172
0173
0176