Basic Position Lost; Basic Position Restore; No Spec: Distance-Coded Scale; R-Pos Adjustment Data Lost - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:

Table of Contents

M800/M80/E80/C80 Series Alarm/Parameter Manual

7 Distance-coded Reference Scale Errors (Z8*)

7Distance-coded Reference Scale Errors (Z8*)

Basic position lost

The basic point data saved in the NC has been damaged.

Set the parameters. If the basic point data is not restored by setting the parameters, perform zero point

initialization.

The basic point data has been restored by setting the parameters.

Turn the power ON again to start the operation.

The distance-coded reference scale has been set available although this function is out of the specifications.

Check the specifications.

If you do not use this function, correct the detector type with the servo parameter.

Reference position adjustment value data saved in the NC has been damaged.

Set the parameter. If the data is not restored by setting the parameter, establish the reference position

R-pos adjustment data restored

After the 'Z81 R-pos adjustment data lost 0001', the data has been recovered by setting the parameter.

Establish the reference position to start the operation.

NC started during SP rotation

The NC was started while the spindle was rotating.

 Turn the power OFF and confirm that the spindle is not rotating, then turn the power ON again.

You can select whether or not to stop the spindle forcibly at the occurrence of this alarm by the setting of the

base common parameter "#1284 ext20/bit1 (Spindle control selected in response to Z83 (NC started during SP

rotation))".

IB-1501279-H

Show Quick Links

Table of Contents

C80 series M80 series E80 series