Setting Parameters - ABB RES670 Technical Manual

Section 15
Logic
15.13.5
15.13.6
470
Name Type
OUT8 BOOLEAN
OUT9 BOOLEAN
OUT10 BOOLEAN
OUT11 BOOLEAN
OUT12 BOOLEAN
OUT13 BOOLEAN
OUT14 BOOLEAN
OUT15 BOOLEAN
OUT16 BOOLEAN

Setting parameters

The function does not have any parameters available in local HMI or Protection and
Control IED Manager (PCM600)
Operation principle
With integer 15 on the input INP the OUT1 = OUT2 = OUT3= OUT4 =1 and the
remaining OUTx = 0 for (5≤x≤16).
OUTx represents a value when activated. The value of each of the OUTx is in
accordance with the table IB16_1. When not activated the OUTx has the value 0.
In the above example when integer 15 is on the input INP the OUT1 has a value =1,
OUT2 has a value =2, OUT3 has a value =4 and OUT4 has a value =8. The sum of
these OUTx is equal to 1 + 2 + 4 + 8 = 15.
This follows the general formulae: The sum of the values of all OUTx = 2
1≤x≤16 will be equal to the integer value on the input INP.
The Integer to Boolean 16 conversion function (IB16) will transfer an integer with a
value between 0 to 65535 connected to the input INP to a combination of activated
outputs OUTx where 1≤x≤16. The sum of the values of all OUTx will then be equal to
the integer on input INP. The values of the different OUTx are according to the table
below. When an OUTx is not activated, its value is 0.
When all OUTx where 1≤x≤16 are activated that is = Boolean 1 it corresponds to that
integer 65535 is connected to input INP. The IB16 function is designed for receiving
the integer input locally. If the BLOCK input is activated, it will freeze the logical
outputs at the last value.
Values of each of the different OUTx from function block IB16 for 1≤x≤16.
Description
Output 8
Output 9
Output 10
Output 11
Output 12
Output 13
Output 14
Output 15
Output 16
Phasor measurement unit RES670 2.2 ANSI
1MRK 511 408-UUS A
ABBD8E242451 v3
SEMOD158385-4 v4
x-1
where
Technical manual