Settings - ABB RES670 Technical Manual

Section 22
Basic IED functions
22.3.4
Table 602: TESTMODE Non group settings (basic)
Name Values (Range)
IEDTestMode Disabled
Enabled
EventDisable Disabled
Enabled
BlockAllFunc Disabled
Enabled
CmdTestEd1 Disabled
Enabled
22.3.5
778

Settings

Unit Step
- -
- -
- -
- -
Operation principle
Set the IED in test mode by
• configuration, activating the input SIGNAL on the function block TESTMODE.
• setting TestMode to Enabled in the local HMI, under Main menu/TEST/IED test
mode.
While the IED is in test mode, the output ACTIVE of the function block TESTMODE
is activated. The other outputs of the function block TESTMODE shows the cause of
the "Test mode: Enabled" state — input from configuration (OUTPUT signal is
activated) or setting from local HMI (SETTING signal is activated).
While the IED is in test mode, the yellow Pickup LED will flash and all functions can
be blocked depending on the configuration of the testmode component. Any function
can be unblocked individually regarding functionality and event signalling.
The deblocking is reseted when exiting test mode.
The blocking of a function concerns all output signals from the actual function, so no
outputs will be activated.
If the IED is restarted while set to IED TESTMODE by a binary input
all functions will be temporarily unblocked during startup, which might
cause unwanted operations.
The TESTMODE function block might be used to automatically block functions when
a test handle is inserted in a test switch. A contact in the test switch (RTXP24 contact
29-30) or an FT switch finger can supply a binary input which in turn is configured to
the TESTMODE function block.
Default Description
Disabled Activate IED Test mode
Disabled Event disable during test mode
Enabled Block all functions when entering IED test
mode
Disabled Require test bit in command at test mode
(only for IEC61850 Ed1)
Phasor measurement unit RES670 2.2 ANSI
1MRK 511 408-UUS A
IP11343-1 v2
PID-6730-SETTINGS v1
IP12116-1 v4
M12015-4 v10
M11828-3 v8
Technical manual