Settings - ABB RES670 Technical Manual

1MRK 511 408-UUS A
19.7.13.5
Table 532: I103GENCMD Non group settings (basic)
Name Values (Range)
FunctionType 1 - 255
PulseLength 0.000 - 60.000
InfNo 1 - 255
19.7.14
19.7.14.1
Phasor measurement unit RES670 2.2 ANSI
Technical manual

Settings

Unit Step
- 1
s 0.001
- 1
IED commands with position and select for IEC 60870-5-103
I103POSCMD
Functionality
I103POSCMD is a transceiver function that monitors activity on its input signals and
interprets any state transition into commands then sent over an established IEC
60870-5-103 link. Additionally, it listens for general interrogation (GI) requests and
replies to those with a GI response message with the current state of each connected
input.
Input POSITION is a double-indication signal, and it is GI enabled. This means that
any state transition, that is to ON, OFF, intermediate and faulty, is reported
spontaneously. However, the intermediate and faulty states may be suppressed by
setting the Report Intermediate Position = Off. See the settings for RS485 and optical
serial communication for more information.
Input SELECT is a single-indication signal, and it is also GI enabled. State transitions
to ON and OFF are reported spontaneously.
When input BLOCK is ON, the function will ignore GI requests and cease all
monitoring activity. Consequently, no transitions will be detected.
The I103POSCMD function is also equipped with two additional commands: Operate
and Cancel. These are hidden in ACT and respond only to base INF +2 and +3
respectively. The base INF (Information Number) parameter is an IEC 60870-5-103
identifier that associates a function in a 103 Master (such as Scada) with its equivalent
in the IED.
Station communication
Default Description
1 Function type (1-255)
0.400 Pulse length
1 Information number for command output
(1-255)
Section 19
PID-3970-SETTINGS v5
GUID-1E40B94D-B6A6-42F0-8757-A47B8A3FA3CD v7
705