Function Block - ABB RES670 Technical Manual

1MRK 511 408-UUS A
19.7.5.3
19.7.5.4
19.7.5.5
Table 512: I103EF Non group settings (basic)
Name Values (Range)
FunctionType 1 - 255
19.7.6
19.7.6.1
Phasor measurement unit RES670 2.2 ANSI
Technical manual

Function block

I103EF
BLOCK
51_EFFW
52_EFREV
IEC10000290-1-en.vsd
IEC10000290 V1 EN-US
Figure 271: I103EF function block
Signals
Table 511: I103EF Input signals
Name Type
BLOCK BOOLEAN
51_EFFW BOOLEAN
52_EFREV BOOLEAN
Settings
Unit Step
- 1
Function status fault protection for IEC 60870-5-103
I103FLTPROT
Functionality
I103FLTPROT is used for fault indications in monitor direction. Each input on the
function block is specific for a certain fault type and therefore must be connected to a
correspondent signal present in the configuration. For example: 68_TRGEN represents
the General Trip of the device, and therefore must be connected to the general trip
signal SMPPTRC_TRIP or equivalent.
The delay observed in the protocol is the time difference in between the signal that is
triggering the Disturbance Recorder and the respective configured signal to the IEC
60870-5-103 I103FLTPROT.
Station communication
Default Description
0 Block of status reporting
0 Information number 51, ground-fault forward
0 Information number 52, ground-fault reverse
Default Description
160 Function type (1-255)
Section 19
GUID-25B47484-2976-4063-BD81-AE02D03B08B0 v1
PID-3974-INPUTSIGNALS v5
PID-3974-SETTINGS v5
GUID-6D52F442-1592-4BA7-919C-0CD79046CAE5 v1
691