Operation Principle - ABB RES670 Technical Manual

Relion 670 series, phasor measurement unit

Hide thumbs Also See for RES670:

Table of Contents

1MRK 511 408-UUS A

Phasor measurement unit RES670 2.2 ANSI

Technical manual

Operation principle

Upon receiving a signal at its input, Generic communication function for Single Point

indication (SPGAPC) function sends the signal over IEC 61850-8-1 to the equipment

or system that requests this signal. Additional configuration is needed with PCM600 or

IET600 to get the IEC 61850-8-1 communication established For more information

refer to the Engineering manual.

Generic communication function for Measured Value

Functionality

Generic communication function for measured values (MVGAPC) function is used to

send the instantaneous value of an analog signal to other systems or equipment in the

substation. It can also be used inside the same IED, to attach a RANGE aspect to an

analog value and to permit measurement supervision on that value.

Station communication

Values (Range)

Output 7 status

Output 8 status

Output 9 status

Output 10 status

Output 11 status

Output 12 status

Output 13 status

Output 14 status

Output 15 status

Output 16 status

Output status logic OR gate

for input 1 to 16

SEMOD55725-5 v7

SEMOD55402-1 v3

SEMOD55872-5 v10

Table of Contents