Technical Data - ABB RES670 Technical Manual

1MRK 511 408-UUS A
17.1.8
17.2
17.2.1
Phasor measurement unit RES670 2.2 ANSI
Technical manual
The BLOCKED signal is a steady signal and is set when the counter is blocked. There
are two reasons why the counter is blocked:
• The BLOCK input is set, or
• The Binary Input Module, where the counter input is situated, is inoperative.
The NEW_VAL signal is a pulse signal. The signal is set if the counter value was
updated since last report.
Note, the pulse is short, one cycle.
The SCAL_VAL signal consists of scaled value (according to parameter Scale), time
and status information.

Technical data

Table 447: PCFCNT technical data
Function
Input frequency
Cycle time for report of
counter value
Function for energy calculation and demand handling
ETPMMTR
Identification
Function description
Function for energy calculation and
demand handling
Setting range
See Binary Input Module (BIM)
(1–3600) s
IEC 61850 IEC 60617
identification identification
ETPMMTR
Section 17
Metering
Accuracy
-
-
SEMOD153638-1 v2
SEMOD175537-2 v4
ANSI/IEEE C37.2
device number
W_Varh -
IP14092-1 v1
M13404-2 v5
599