Pulse Timer Function Block Pulsetimerqt - ABB RES670 Technical Manual

1MRK 511 408-UUS A
15.8.7
15.8.7.1
15.8.7.2
Phasor measurement unit RES670 2.2 ANSI
Technical manual

Pulse timer function block PULSETIMERQT

The pulse timer function block (PULSETIMERQT) can be used, for example, for pulse
extensions or for limiting the operation time of the outputs. PULSETIMERQT has a
settable output pulse length.
When the input goes to 1, the output will be 1 for the time set by the time delay
parameter t. Then it returns to 0.
When the output changes value, the time stamp of the output signal is updated.
The supported "quality" state bits are propagated from the input to the output at each
execution cycle. A change of these bits will not lead to an updated time stamp on the
output.
PULSETIMERQT can propagate the quality, value and the time stamps of the signals
via IEC 61850.
Function block
PULSETIMERQT
INPUT OUT
IEC15000145.vsd
IEC15000145 V1 EN-US
Figure 175: PULSETIMERQT function block
Signals
Table 310: PULSETIMERQT Input signals
Name Type
INPUT BOOLEAN
Table 311: PULSETIMERQT Output signals
Name Type
OUT BOOLEAN
Default Description
0 Input signal
Description
Output signal
Section 15
Logic
GUID-5CB71BD1-58A0-4A06-9207-6DAE389B5288 v2
GUID-D930E5A7-C564-4464-B97F-C72B4801C917 v4
GUID-C0490ECF-5C4E-4F17-B628-482694C590D2 v1
GUID-4543C4C9-FAE2-4328-8DE2-4A5756A020E9 v1
PID-3810-INPUTSIGNALS v5
PID-3810-OUTPUTSIGNALS v5
453