Settings - ABB RES670 Technical Manual

Section 6
Wide area measurement system
6.1.4
Table 44: PMUCONF Non group settings (basic)
Name Values (Range)
1344TCPport 1024 - 65534
C37.118TCPport 1024 - 65534
TCPportUDPdataCtrl1 1024 - 65534
SendDataUDP1 Disabled
Enabled
SetByProtocol
ProtocolOnUDP1 IEEE1344
C37.118
PMUReportUDP1 1 - 2
UDPDestAddres1 0 - 16
UDPDestPort1 1024 - 65534
SendCfgOnUDP1 Disabled
On
TCPportUDPdataCtrl2 1024 - 65534
SendDataUDP2 Disabled
Enabled
SetByProtocol
Table continues on next page
108
The PMU clients receiving the UDP frames can also connect to the IED to request
(command frame) config frame 1, config frame 2, config frame 3, or header frame, and
to disable/enable real time data. This can be done by connecting to the TCP port
selected in TCPportUDPdataCtrl[x] for each UDP group. This connection is done
using TCP. The IED allows 4 concurrent client connections for every
TCPportUDPdataCtrl[x] port (for each UDP client group[x]).
If the client tries to connect on TCPportUDPdataCtrl[x] port using a PMU-ID other
than what is configured for that PMUREPORT instance (PMUReportUDP[x]), then
that client is immediately disconnected and the UDPCtrlCfgErrCnt is incremented in
PMU Diagnostics on LHMI at Main menu/Diagnostics/Communication/PMU
diagnostics/PMUSTATUS:1
Even if the parameter SendDataUDP[x] is set to Disable it is still possible for the
clients to connect on the TCP port and request the configuration frames.

Settings

Unit Step
- 1
- 1
- 1
- -
- -
- 1
IP 1
Address
- 1
- -
- 1
- -
Default Description
4711 TCP port for control of IEEE 1344 data for
TCP clients
4712 TCP port for control of IEEE C37.118 data for
TCP clients
4713 TCP port for control of data sent over UDP
client group1
Disabled Send data to UDP client group1
C37.118 Select protocol for UDP client group1
1 PMUREPORT instance used for UDP client
group1
234.5.6.7 UDP destination address for UDP client
group1
8910 UDP destination port for UDP client group1
Disabled Send Config frame2 on UDP for group1
4714 TCP port for control of data sent over UDP
client group2
Disabled Send data to UDP client group2
Phasor measurement unit RES670 2.2 ANSI
1MRK 511 408-UUS A
SEMOD119927-1 v2
PID-6710-SETTINGS v4
Technical manual