Settings - ABB RES670 Technical Manual

1MRK 511 408-UUS A
15.12.5
15.12.6
15.12.7
Phasor measurement unit RES670 2.2 ANSI
Technical manual
Name Type
IN12 BOOLEAN
IN13 BOOLEAN
IN14 BOOLEAN
IN15 BOOLEAN
IN16 BOOLEAN
Table 339: BTIGAPC Output signals
Name Type
OUT INTEGER

Settings

The function does not have any parameters available in the local HMI or PCM600.
Monitored data
Table 340: BTIGAPC Monitored data
Name Type
OUT INTEGER
Operation principle
The Boolean 16 to integer conversion with logic node representation function
(BTIGAPC) will transfer a combination of up to 16 binary inputs INx, where 1≤x≤16,
to an integer. Each INx represents a value according to the table below from 0 to
32768. This follows the general formula: INx = 2
values on the activated INx will be available on the output OUT as a sum of the integer
values of all the inputs INx that are activated. OUT is an integer. When all INx (where
1≤x≤16) are activated, that is = Boolean 1, it corresponds to that integer 65535 is
available on the output OUT. If the BLOCK input is activated, it will freeze the logical
outputs at the last value.
Values of each of the different OUTx from function block BTIGAPC for 1≤x≤16.
The sum of the value on each INx corresponds to the integer presented on the output
OUT on the function block BTIGAPC.
Default Description
0 Input 12
0 Input 13
0 Input 14
0 Input 15
0 Input 16
Description
Output value
Values (Range) Unit
- -
x-1
where 1≤x≤16. The sum of all the
Section 15
Logic
PID-6944-OUTPUTSIGNALS v2
ABBD8E283673 v3
PID-6944-MONITOREDDATA v2
Description
Output value
SEMOD158425-4 v6
467