Signal Flow And Input/Output Symbols In The Block Diagram; Working With R&S Sgma-Gui; Storing And Loading Settings - R&S SGT100A User Manual

®
R&S SGT100A

6.4.2 Signal Flow and Input/Output Symbols in the Block Diagram

The input/output symbols in the block diagram show the currently used inputs and out-
puts of the signal generator. Unused inputs and outputs are not shown. The lines indi-
cate the signal flow.
Symbols and labels refer to the corresponding inputs and outputs on the front and rear
panel of the signal generator. The direction - input or output - is indicated by an arrow.
Example:
Symbols and lines are displayed in different colors depending on their function.
●
The baseband signal is indicated by a three line arrow, the I- and Q-components of
the signal by a single-line arrow.
●
Connections are indicated by a "solder point".
●
Black is used for the generated signal.
●
Green is used for control signals.
6.5 Working with R&S SGMA-GUI
This section explains how to work with the R&S SGMA-GUI software and perform con-
figuration tasks for manual operation of the instruments.

6.5.1 Storing and Loading Settings

To proceed work with a particular configuration of the instruments in the R&S SGMA-
GUI, it is useful to save the used settings and load them again later.
How to store and load settings
1. Select "SGMA-GUI main panel > File > Save As".
2. Navigate to the desired directory and enter the filename.
The extension *.savrcl is applied automatically.
The current settings of the software are saved to the selected file.
3. To load settings from a file, select "SGMA-GUI main panel > File > Open"
4. Navigate to the directory the file is stored in and select the setting file.
User Manual 1176.8674.02 ─ 07
Understanding the R&S SGMA-GUI Software
The symbols indicate the inputs for the analog I and Q signal.
Working with R&S SGMA-GUI
62