[:Source<Hw>]:Bbin:digital:asetting:state [:Source<Hw>]:Bbin:foffset; [:Source<Hw>]:Bbin:gimbalance; [:Source<Hw>]:Bbin:iqswap[:State] - R&S SGT100A User Manual

®
R&S SGT100A
Example:
Manual operation:
[:SOURce<hw>]:BBIN:FOFFset <FOffset>
Enters the frequency offset for the external baseband signal.
The complex I/Q bandwidth of the shifted useful signal must not exceed the total avail-
able baseband bandwidth (see data sheet).
Parameters:
<FOffset>
Example:
Manual operation:
[:SOURce<hw>]:BBIN:GIMBalance <GImbalance>
This command enters a gain to the Q component of the external baseband signal.
Parameters:
<GImbalance>
Example:
[:SOURce<hw>]:BBIN:IQSWap[:STATe] <State>
This command swaps the I and Q channel if set to ON.
Parameters:
<State>
Example:
Manual operation:
User Manual 1176.8674.02 ─ 07
BBIN:DIG:ASET:STAT ON
switches on automatic adjustment of the baseband input signal.
See "DIG IQ Auto Setting"
float
Range: -40E6 to 40E6
Increment: 0.01
*RST: 0
Default unit: Hz
BBIN:FOFF 2 MHz
sets a frequency offset of 2 MHz.
See "Frequency Offset"
float
Range: -3 to 3
Increment: 0.001
*RST: 0
Default unit: dB
BBIN:GIMB -1.0dB
amplifies the Q component of the external input signal with -1.0
dB.
0 | 1 | OFF | ON
*RST: 0
BBIN:IQSW ON
swaps the I and Q channel of the external baseband signal.
See "I/Q-Swap" on page 238
Remote Control Commands
SOURce Subsystem
on page 240
on page 242
402