Pulse Connector/Trigger Settings - R&S SGT100A User Manual

®
R&S SGT100A
Remote command:
[:SOURce<hw>]:PULM:PERiod
Pulse Width
Sets the pulse duration of the generated pulse signal.
Remote command:
[:SOURce<hw>]:PULM:WIDTh
Double Pulse Width
Sets the width of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:WIDTh
Double Pulse Delay
Sets the delay between the start of the first pulse and the start of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:DELay
7.7.9.3

Pulse Connector/Trigger Settings

► To access the pulse connector/trigger settings, select "SGMA-GUI > Instrument
Name > RF> Pulse Modulation > Connector/Trigger".
Comprises the settings necessary to configure the signal at the multi-purpose TRIG
connector in the external trigger mode.
Mode
Selects the mode for the correspondent connector. Some settings are only available
for connector USER 2.
"Marker 1/2"
"Trigger/ Trigger Out"
"Clock In/Out"
"Sync In/Out"
"Next Trigger"
"Signal Valid"
User Manual 1176.8674.02 ─ 07
on page 463
on page 465
Output for a defined marker signal.
Input/output for an external trigger signal.
Input/Output for a clock signal.
Input/Output for SYNC signals used for SYNC-Mode in baseband.
Input next segment for triggering of multi-segment waveform files.
Output of high signal to mark valid frequency and level settings.
Signal Generator Settings
on page 462
on page 462
RF Settings
232