R&S SGT100A User Manual page 495

®
R&S SGT100A
Parameters:
<Source>
Manual operation:
[:SOURce<hw>]:PULM:STATe <State>
Activates the pulse modulation.
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:GATE:POLarity <Polarity>
Selects the polarity of the Gate signal.
Parameters:
<Polarity>
Example:
Manual operation:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:IMPedance <Impedance>
Selects the impedance for external pulse trigger.
Parameters:
<Impedance>
Example:
Manual operation:
User Manual 1176.8674.02 ─ 07
INTernal | EXTernal
INTernal
The internal pulse generator is used for the pulse modulation.
EXTernal
The signal applied externally via the trigger connector is used for
the pulse modulation.
*RST: INTernal
See "Source" on page 231
0 | 1 | OFF | ON
*RST: 0
PULM:STAT ON
activates pulse modulation.
See "State" on page 230
NORMal | INVerted
*RST: NORMal
PULM:TRIG:EXT:GATE:POL NORM
The pulse signal is generated while the gate signal is high.
See "Gate Input Polarity"
G50 | G10K
*RST: G50
SOUR:PULM:TRIG:EXT:IMP G50
selects 50 Ohm as the trigger impedance for the external pulse
trigger.
See "External Impedance"
Remote Control Commands
SOURce Subsystem
on page 233
on page 231
464