Preset Commands - R&S SGT100A User Manual

®
R&S SGT100A
Parameters:
<LockRequestId>
Return values:
<Value>
Example:
Usage:
Manual operation:
:UNLock <UnlockId>
Unlocks an instrument locked to a controller with Controller ID = <Unlock Id>.
Setting parameters:
<UnlockId>
Usage:
Manual operation:

11.3 Preset Commands

The preset commands are not bundled into one subsystem. Therefore, they are listed
separately in this section. These specific commands are described in the associated
subsystems.
The following presetting actions are available:
●
Activating the default state of all internal instrument functions
Functions that concern the integration of the instrument into a measurement setup
are not changed, e.g. TCP/IP address or reference oscillator source settings.
User Manual 1176.8674.02 ─ 07
Number
0
test query to prove whether the instrument is locked
Controller ID
request lock from the controller with the specified Controller ID
Number
0
request refused; the instrument is already locked to other <Lock
Request Id>, i.e. to another controller
1
request granted
:LOCK? 12345
Response: 1
:UNL 12345
Query only
See "Exclusive Access"
Number
Unlock ID which uniquely identifies the controller to the instru-
ment. The value must match the Controller ID <Lock Request
Id> set with the command :LOCK?.
0
Clear lock regardless of locking state
Setting only
See "Exclusive Access"
Remote Control Commands
Preset Commands
on page 53
on page 53
(*RST on page 307).
310