[:Source<Hw>]:Bb:arbitrary:wsegment:configure:marker:esegment; [:Source<Hw>]:Bb:arbitrary:wsegment:configure:marker:fsegment - R&S SGT100A User Manual

®
R&S SGT100A
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
User Manual 1176.8674.02 ─ 07
UNCHanged | ERMS
UNCHanged
The segments are output exactly as defined in the files.
ERMS
The segments are output so that all segments have the same
rms value.
*RST:
BB:ARB:WSEG:CONF:LEV:MODE UNCH
selects level mode unchanged. The segments are output as
defined in the waveform file.
See " Level "
<Mode>
OFF | MRK1 | MRK2 | MRK3 | MRK4
OFF
No additional marker is generated.
MRK1|MRK2|MRK3|MRK4
Generates a restart marker signal at the beginning of each seg-
ment for the corresponding marker.
The segment begin is defined by the low-high slope of the
marker. This applies for switching between two segments as
well as in case of segment replay.
*RST:
BB:ARB:WSEG:CONF:SEL 'ConfComm'
BB:ARB:WSEG:CONF:MARK:ESEG MRK3
See " Segment Restart "
<Mode>
Remote Control Commands
UNCHanged
on page 89
OFF
on page 90
SOURce Subsystem
394