Arb - R&S SGT100A User Manual

®
R&S SGT100A
The ARB waveform for the envelope tracking ("Baseband 2") uses the same trigger,
marker and clock settings as the first ARB waveform ("Baseband").
For more information on the envelope tracking, see
lope Tracking
System Configuration
Selects the signal flow settings.
"Standard"
"ARB for Envelope Tracking"
Remote command:
:SCONfiguration:MODE
Apply
Triggers the instrument to adopt the selected configuration.
OK
Applies the configuration and exits the dialog.

7.1.2 ARB

The Arbitrary Waveform Generator (ARB) is an I/Q modulation source forming an inte-
gral part of the R&S SGT. The ARB allows the playback and output of any externally
calculated modulation signals in the form of waveform files and the generation of multi-
carrier or multi-segment signals from waveform files.
User Manual 1176.8674.02 ─ 07
Signals", on page 146.
Selects the standard mode for the signal generator.
When this mode is enabled, a second ARB signal is generated, which
is output at the analog output connectors. This ARB can be only used
for envelope tracking.
on page 328
Signal Generator Settings
Chapter 7.5, "Generation of Enve-
Baseband
77