Nrp Sensor Mapping - R&S SGT100A User Manual

®
R&S SGT100A
Since the settings are interdependent, the affected parameters change accordingly if
you set a value.
To fill the table, press the "Execute" button.
To select the sensor and determine its parameters, refer to
Viewer",
Fill User Correction Data with Sensor
●
"Sensor"
Displays connected sensors for selection.
●
"List To Fill"
Indicates the used list.
●
"Include Zeroing"
Performs a zeroing procedure before acquiring the user correction data to improve
precision. Since during zeroing no signal may be applied to the sensor, RF is tem-
porarily switched off at the generator.
When unchecked, the zeroing procedure is skipped. However, the RF signal level
might be blanked shortly. This setting is recommended if blanking of RF is undesir-
able or the absence of power at the sensor cannot be guaranteed.
●
"Execute"
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:ZERoing:STATe
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 417
Used Instrument Settings For Measurement
Displays the settings relevant for the measurement.
"Modulation"
"Amplitude"
"Use SParameter"
"Attenuator Mode"
"Fixed range (PEP) In"
Remote command:
n.a.

7.7.7 NRP Sensor Mapping

The "NRP Sensor Mapping" lists all R&S NRP sensors detected by the signal genera-
tor.
User Manual 1176.8674.02 ─ 07
on page 221.
Indicates the modulation state
Shows the currently set level.
Indicates whether SParameter correction is used.
Displays the selected mode of the attenuator.
Shows the level range.
Signal Generator Settings
RF Settings
Chapter 7.7.8, "NRP Power
on page 422
219