General Analog I/Q Output Settings; Settings: State - R&S SGT100A User Manual

®
R&S SGT100A

7.4.1 General Analog I/Q Output Settings

Access:
► Select "I/Q Analog > I/Q Analog Settings > General".
Settings:
State............................................................................................................................142
Set to
Save/Recall................................................................................................................. 143
RF Envelope............................................................................................................... 143
I/Q Output
Mode........................................................................................................................... 144
I/Q Level Vp
Couple I/Q
Bias
Offset
State
Enables/disables the analog I/Q output.
Note: By default, these output connectors are deactivated.
Remote command:
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe
Set to Default
Calls the default settings. The values of the main parameters are listed in the following
table.
User Manual 1176.8674.02 ─ 07
Default.............................................................................................................. 142
Type...........................................................................................................143
EMF........................................................................................................144
Bias........................................................................................................... 144
(EMF).................................................................................................................. 144
(EMF)................................................................................................................145
Signal Generator Settings
I/Q Analog Output Settings
on page 426
142